MTX THUNDER500.1 Class D 500W Mono Block Amplifier Thunder Series

MTX THUNDER500.1 Class D 500W Mono Block Amplifier Thunder Series

Upgrade your power for better sound

You'll get some serious MTX bass mojo when you put the MTX THUNDER500.1 mono amp in your car. This compact amp will drive your subwoofer setup with up to 500 watts RMS. Hook this amp up to a nice set of subs, and you'll hear sounds you've never heard before, even in your favorite songs. And this little bruiser will truly fit in places where amps don't usually go.

MTX THUNDER 500.1 control panel

Advanced tone control

You can adjust the low-pass filter and subsonic filter to get the best possible sound from your sub and enclosure. In the unlikely event you want to bump up the bass a little, you also have access to a selectable bass boost.

Confused about impedance? Check out our article on matching subs and amps.

Features:

• mono subwoofer amplifier
• 300 watts RMS x 1 at 4 ohms (500 watts RMS x 1 at 2 ohms)
• variable low-pass filter (40-220 Hz, 12 dB/octave)
• selectable bass boost (0, 6, 12 dB at 50 Hz)
• variable subsonic filter (20-50 Hz, 12 dB/octave)
• Class-D amplifier design
• frequency response: 20-220 Hz
• preamp inputs
• 4-gauge power and ground leads and a 60-amp fuse recommended - wiring and hardware not included with amplifier
• no onboard fuses - when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended
• 9-1/2"W x 2-1/4"H x 6-5/16"D
• warranty: 2 years

in the box:

• Mono subwoofer amplifier
• 4mm Allen wrench
• 2mm Allen wrench
• Four 1/2" Self-tapping screws