PAC LPHCH41 LOCPRO Advanced T-Harness 4 Channels Fits For Chrysler 2013-Onwards

PAC LPHCH41 LOCPRO Advanced T-Harness 4 Channels Fits For Chrysler 2013-Onwards

Upgrade Fits For Chrysler-Built Radio

Adding an aftermarket amplifier will beef up the sound of any audio system, even when you can't replace the factory radio. PAC's LPHCH41 LOCPRO Advanced T-harness makes amplifier installation a lot easier by giving you access to the speaker-level output signals from your Chrysler-built factory radio. You can use this T-harness to connect to an amplifier or signal processor with speaker-level inputs, or to a line output converter with an amp.

Provides Signal For Your System

PAC designed this vehicle-specific T-harness to work with their LPA LOCPRO Advanced line output converters, but it'll also work with almost any sound processor or line output converter, as well as most amplifiers with high-level inputs. The harness also supplies the connection wires for low-power constant 12 volts (fused for your protection), accessory power, ground, and remote turn-on leads for a system device like an active signal processor.

Note: The power and ground wires in this harness will only support a low-current accessory, like an active line output converter or digital signal processor, and should not be used to power an amplifier.

How It Works

First, you unplug the radio, and install the T-harness. One T-harness plug goes into the radio, the other snaps into the plug you just took out. You're then left with the radio still completely connected to your vehicle, with the addition of a pigtail of wires to use for adding an amp.

It Comes Wired For Adding A Sub

The T-harness pigtail includes four speaker-level channels, eight wires, that you can use for the sub amp's inputs. The amplifier will have to get its power and ground connections separately. The factory radio will still run all the speakers.

For Powering A System, You'll Need To Cut And Splice Some Wires

You can use all four of the T-harness's speaker-level channels for your aftermarket system's inputs. PAC has made provisions in this harness for sending your aftermarket amplifier's outputs back through the factory wiring and on to the speakers. The appropriate wire bundle has clearly marked labels showing you which wires to cut and where, which wires you'll need to cap off, and which wires you'll need to connect to your aftermarket amplifier's outputs.

Note: Fits For Chrysler radio systems will require load resistors for the system upgrade to operate properly. You can often find them built into a sound processor, like PAC's LOCPRO Advanced line output converters. Otherwise, you'll have to purchase your load resistors separately.

Product Highlights:

• T-harness for adding an amp to a non-amplified system
• Fits select 2013-up Chrysler-built vehicles
• 4 Channels of speaker-level signals from factory radio
• Low-power 12-volt, ground, accessory, and remote turn-on connections
• In-line fuse on 12V power wire
• Remote turn-on signal output with butt connector
• Works with PAC LOCPRO Advanced line output converters, and most amps and sound processors with speaker-level inputs
• Warranty: 1 year
• Our 60-day money-back guarantee
• MFR LPHCH41

What's In The Box:

• PAC LPHCH41 LOCPRO Advanced T-Harness owner's manual
• 9" Wiring harness
• 10 Amp ATM fuse (installed in fuse holder)
• Instruction guide